This equipment cools the air for cooling the gas turbine rotor with the high-pressure water supply of the waste heat recovery boiler.

This equipment heats feed water by turbine bleed to improve the thermal efficiency of a steam turbine plant.
Heating the water supply saves the amount of heat required to boil the steam.

As with the low-pressure feed water heater, this equipment heats the feed water by turbine bleed to improve the thermal efficiency of the steam turbine plant. The feed water pressure is higher than that of the low-pressure feed water heater.

This equipment heats the fuel gas sent to the gas turbine combustor by the water supply from the waste heat recovery boiler to improve the combustion efficiency.

Equipment for re-cooling the cooling water in the places where it has been received from each cooling device, such as an oil cooler or a generator hydrogen cooler, to a predetermined temperature with seawater or cooling tower water.

A equipment for heating heavy oil with steam, etc., so that the spray combustion is optimal with a boiler combustion burner.

Equipment for cooling the lubricating oil in the bearing.

By cooling and condensing the steam exhausted from the steam turbine using seawater or cooling tower water, this equipment keeps the turbine back pressure at a vacuum to improve the thermal efficiency of the plant, and recirculate the condensed steam to the turbine cycle.

The steam converter is a equipment that uses the main steam and turbine bleed air to generate on-site steam (heater steam, air heating steam, etc.) for power generation facilities and other facilities using water from another system.

This equipment cools the air for cooling the gas turbine combustor (compressor air) by steam condensate.

This equipment aims to heat boiler feed water and remove dissolved oxygen in feed water by directly mixing turbine bleed air and boiler feed water.

Equipment to generate flash steam and separate from the drain for recovering heat from generated steam, by flowing blow water discharged from the boiler into the vessel and depressurizing it.

This equipment uses low-pressure or high-pressure steam to heat the combustion air to a specified temperature in order to improve the boiler combustion efficiency.

This equipment is used to reheat boiler exhaust gas with steam to a predetermined temperature, and to prevent corrosion of the exhaust gas flue on the wake side.

This equipment uses boiler waste heat to heat boiler feed water to a specified temperature, and improve plant thermal efficiency.

Equipment for cooling air using seawater as cooling water.